Kohler Command CH20 Service Manual page 59

Remove Throttle and Choke Controls (Mechanical
Governor)
Control Bracket Components (Mechanical
Governor)
A Choke Linkage
C Spring
E Nut
1. Remove screws securing control bracket and rear air
cleaner bracket (some models) to cylinder heads.
2. Mark spring hole locations and disconnect spring
from governor lever.
3. Remove choke linkage from choke actuator lever
and carburetor.
Remove External Governor Controls (Mechanical
Governor)
Loosen nut and remove governor lever from cross shaft.
Leave lever attached to throttle linkage and lay assembly
on top of crankcase.
24 690 30 Rev. G
A
C
F
E
D
B Control Bracket
D Governor Lever
F Throttle Linkage
KohlerEngines.com
Disassembly/Inspection and Service
Remove Carburetor (Mechanical Governor)
Explosive Fuel can cause fi res and severe
burns.
If a gaseous odor is detected, ventilate area
and contact an authorized service technician.
LPG is extremely fl ammable and is heavier than air
and tends to settle in low areas where a spark or fl ame
could ignite gas. Do not start or operate this engine
B
in a poorly ventilated area where leaking gas could
accumulate and endanger safety of persons in area.
NG is extremely fl ammable, is lighter than air, and
rises. Do not start or operate this engine in a poorly
ventilated area where leaking gas could accumulate
and endanger safety of persons in area.
To ensure personal safety, installation and repair of
LPG/NG fuel supply systems must be performed only
by qualifi ed LPG/NG system technicians. Improperly
installed and maintained LPG/NG equipment could
cause fuel supply system or other components to
malfunction, causing gas leaks.
Observe federal, state and local laws governing LPG/
NG fuel, storage, and systems.
1. Disconnect ground lead, if equipped.
2. Remove carburetor mounting screws or nuts.
3. Remove carburetor, throttle linkage and governor
lever as an assembly.
4. Remove carburetor gasket.
5. If necessary, carburetor, throttle linkage and
governor lever can be separated. Reattach bushings
to linkage following separation to avoid losing them.
WARNING
59