Table of Contents
Advertisement
11.4 ENGINE ACTUATOR REPLACE-
MENT
11.4.1 Actuator Removal
WARNING
CRUSHING HAZARD
Ensure the seed tender is blocked to
prevent movement.
Ensure the engine is not running and
remove the key during the following
procedures. Serious injury or death
can result from being caught in moving
parts.
1. Remove bolt (1) that secures cover (2) to
actuator mounting bracket (3). Remove the
cover.
2. Disconnect the actuator cable from the engine
harness at connector (4).
3. Remove four bolts (5), washers (6), lock nuts
(7) and spacers (8).
4. Remove washer nut (9) and then disconnect
spring (10) from the actuator arm (11).
11.4.2 Actuator Installation
1. Connect the cable of the new actuator to
engine harness connector (4).
2. Position actuator arm (11) so it is pointing
away from the end where the cable is attached
to the unit, as shown. Use the actuator switch
(12) on the delivery tube to position the arm.
Note: Do not move the arm manually or the unit
will be damaged.
41
Advertisement
Table of Contents
