Mission Critical Geofence; Entering Mission Critical Geofence; Exiting Mission Critical Geofence; Trunking System Controls - Motorola APX 8000 User Manual

When the radio exits the Geofence area, your radio reverts to original channel or newly assigned
talkgroup. The radio display shows the new channel together with Voice Announcement to indicate the
changes. Voice Announcement of the new channel only works if that channel is configured with Voice
Announcement.
7.17.2

Mission Critical Geofence

This feature allows the radio to use the GPS receiver to determine radio location at frequent intervals
and evaluate if the radio is within the Geofence area in real time
Check with your dealer or qualified technician to program the geofence coordinates and actions.
7.17.3

Entering Mission Critical Geofence

When and where to use:
When the radio enters the predefined Geofence area, the radio displays <Geofence Alias> with
the intelligent backlight and you hear a Voice Announcement. Zone and channel alias of the Geofence
area is displayed. If the radio is set to manual, you can choose either to proceed with zone and
channel change or cancel the change.
The radio then connects to the designated talkgroup. The radio displays the talkgroup alias and
dynamic regroup tone sounds. The transmit power level changes and the radio shows a direct text
message content without any user operation.
NOTE:
The availability of the Voice Announcement (VA), TMS display, Intelligent Backlight, and
Transmit Power Level alerts depend on your radio configuration. The VA can be programmed to
alert continuously or momentarily.
If Site Selectable Alert (SSA) is enabled, the radio mutes any alert that is received when
entering the Geofence area and unmutes when exiting.
7.17.4

Exiting Mission Critical Geofence

When and where to use:
When the radio exits the Geofence area, the radio reverts to the original transmit power level,
intelligent lighting, channel, or newly assigned talkgroup. Voice announcement is canceled or you hear
a preprogrammed VA tone. The radio displays the new channel and a message is received to indicate
the changes.
7.18

Trunking System Controls

This chapter explains the trunking system control features in your radio.
7.18.1

Operating in Failsoft System

When and where to use:
The failsoft system ensures continuous radio communication during a trunked system failure. If a
trunking system fails completely, the radio goes into failsoft operation and automatically switches to its
failsoft channel.
MN001422A01-AW
Chapter 7 : Advanced Features
61