Table of Contents
Advertisement
To activate the Fast Clean programme:
GB
1. Switch the control panel on by pressing the
2. Press button
; the display will show the text "Piro", "nor" and the default
duration of 1:30 h (normal cycle) alternately.
3. Press button
, then turn the TIMER knob to adjust the default cleaning
level. There are 3 different levels to choose from, each with a pre-set duration
1. Economy (ECO): turn the knob towards "-". Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards "+". Duration 2 hours.
4. Press the
5. Press the
button to begin the cleaning cycle.
An end time for the FAST CLEAN cycle (as for a normal cooking cycle) may
be programmed (see Programming the automatic cleaning end time).
Safety devices
• the door locks automatically as soon as the temperature reaches a high
value; the
icon lights up on the display;
• pressing the
button cancels the cleaning cycle at any time;
• if a malfunction occurs, the heating elements will be switched off;
• once the oven door has been locked, you cannot change the duration and
end time settings.
Troubleshooting
Problem
The "Clock button" and the digits on the
display flash.
A programmed cooking mode does not
start.
Only the high luminosity "Clock button"
is lit.
An automatic mode has been selected.
"Hot" appears on the
display and
cooking does not start.
Fan-assisted cooking has been
selected and the food looks burnt.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
18
Programming the automatic cleaning end time
1. Press the
button.
2. Turn the TIMER knob towards "+" and "-" to adjust the cleaning end time
value.
3. Once you have reached the desired end time, press the
The display will show the duration, the cleaning end time and the set cleaning
level alternately.
4. Press the
Programming has been set when the
sounds.
• For example: it is 9:00 a.m. and the Economy (ECO) FAST CLEAN level
has been selected, with the default duration of 1 hour. 12:30 is scheduled
as the end time. The programme will start automatically at 11:30 a.m.
To cancel programming press the
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait for the
switch off: this indicates the oven temperature has dropped to an acceptable
level. You will notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge once the oven
has cooled down completely. Alternatively, you can make use of the already
heated oven, in which case it is not necessary to remove the deposits, they
are completely harmless and will not affect your food in any way.
Possible cause
The appliance has just been connected to the
electricity mains or there has been a blackout.
There has been a blackout.
The appliance is in
standby mode.
The temperature inside the oven is higher
than the suggested value for the selected
mode.
Positions 1 and 5: the direct heat could cause
temperature-sensitive foods to burn.
button twice: the
icon and the numerical digits on the
button to activate the programmed mode.
and
buttons are illuminated.
button.
Solution
Set the clock.
Reprogram the cooking mode.
Press any button to exit standby mode.
Wait for the oven to cool down.
We recommend switching dripping pan
positions halfway through cooking.
button again.
icon to
Advertisement
Table of Contents
