Wiring; Front Panel Layout; Two Channel Inputs And Controls - Soundstream Tarantula TRA1000.2 Owner's Manual And Installation Manual

Factory Ground wire may
need to be replaced if it is
frayed or broken.
Run signal cables (RCAs)
and remote turn-on lead
down the opposite side of
the vehicle of the power
wire to avoid radiated noise.
Avoid sharp edges that
could chafe through the
insulation.
Warning!A Main Fuse must be installed within 18 of bat tery!
Positive
Battery
Terminal
Fuse must be
installed within
18 of battery
Drill a hole in the firewall
and use a rubber grommet
High Pass/BP filter(HPF or BP x-over)
to keep wire from shorting.
Low Pass/BP filter(LPF or BP x-over)
Note:Push both switches IN for BP Crossover Function.
Run the cables under the
carpet near the side of the
vehicle. Be careful not to
drill or screw into the wires
when you replace the trim.
For systems ov er 300 watts,
Run a ground cable from the
amp to the battery instead of
grounding t o t he rear chassis.
For Systems under
300W,Ground Wire
to solid metal of r ear
chassis.
0.2-4V/4.2-8V