Summary of Contents for Soundstream Tarantula TRA1000.2
Page 2
Five channel inputs and controls Five channel speaker wiring 12-13 14-17...
Page 4
Factory Ground wire may need to be replaced if it is frayed or broken. Run signal cables (RCAs) and remote turn-on lead down the opposite side of the vehicle of the power wire to avoid radiated noise. Avoid sharp edges that could chafe through the insulation.
Page 5
0.2-4V/4.2-8V High Pass/BP filter(HPF or BP x-over) Low Pass/BP filter(LPF or BP x-over) Note:Push both switches IN for BP Crossover Function.
Page 7
0.2-4V/4.2-8V High Pass/BP filter(HPF or BP x-over) Low Pass/BP filter(LPF or BP x-over) Note:Push both switches IN for BP Crossover Function. 2 OHM MAXIMUM PER CHANNEL...
Page 8
0.2-4V/4.2-8V High Pass/BP filter(HPF or BP x-over) Low Pass/BP filter(LPF or BP x-over) Note:Push both switches IN for BP Crossover Function. 4 (OHM MAX)
Page 10
4 OHM MAX BASS FRONT PANEL LAYOUT FIVE CHANNEL INPUTS AND CONTROLS RCA Output: Provides a full range signal output to drive other amplifier RCA Input: Input from the source unit. Input modes: Allows selection between 0.2-4V/4.2-8V. Gain Adjust: Used to adjust gain to match source unit. Bass Boost: Adjust this control for 0 to +12dB of bass boost High Pass/BP filter(HPF or BP x-over)
Page 11
FIVE CHANNEL SPEAKER WIRING 2 OH M MAX P ER CHANN EL CROS SO VER REMOTE TURN ON FROM HEAD UNIT 2 OH M MAX GROUND TO CHASSIS WIRE LENGTH 18 P ER CHANN EL TO BATTERY. FUSE MUST BEINSTALLED WITHIN 18 OF THE BATTERY CROS SO VER 2 OHM MAX...