TP-Link Omada EAP615 User Manual page 83

• Dynamic
If you choose Dynamic as the IP address mode, make sure that there is a reachable
DHCP server on your network and the DHCP sever is properly configured to assign IP
address and the other network parameters to the EAP.
For network stability, you can also configure the fallback IP parameters for the EAP:
Fallback IP
DHCP Fallback IP
DHCP Fallback IP MASK
DHCP Fallback Gateway
• Static
If you choose Static as the IP address mode, you need to manually specify an IP
address and the related network parameters for the EAP. Make sure that the specified
IP address is not being used by any other device in the same LAN.
With the fallback IP configured, if the EAP fails to get an IP
address from a DHCP server within 10 seconds, the fallback
IP will work as the IP address of the EAP. After that, however,
the EAP will keep trying to obtain an IP address from the DHCP
server until it succeeds.
Specify a fallback IP address for the EAP. Make sure that this IP
address is not being used by any other device in the same LAN.
The default DHCP fallback IP is 192.168.0.254.
Specify the network mask of the fallback IP. The default DHCP
fallback IP mask is 255.255.255.0.
Specify the network gateway.
79