Makita HS012G Instruction Manual page 14

For tool with the inner flange for a
15.88 mm hole-diameter saw blade
(country specific)
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place circu-
lar saw blade (with the ring attached if needed), outer
flange and hex bolt.
For tool without the ring
1 2
Fig.22
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
blade 4. Outer flange 5. Hex bolt
For tool with the ring
1 2
15.88
Fig.23
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
blade 4. Outer flange 5. Hex bolt 6. Ring
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
WARNING:
If the ring is needed to mount the
blade onto the spindle, always be sure that the
correct ring for the blade's arbor hole you intend
to use is installed between the inner and the outer
flanges. Use of the incorrect arbor hole ring may
result in the improper mounting of the blade causing
blade movement and severe vibration resulting in
possible loss of control during operation and in seri-
ous personal injury.
Removing circular saw blade
1.
base down.
2.
shaft cannot revolve and use the hex wrench to loosen
the hex bolt. Then remove the hex bolt, outer flange,
circular saw blade and ring (country specific).
3.
shaft lock and tighten the hex bolt.
Blade guard cleaning
5
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
section. Such efforts do not replace the need to check
lower guard operation before each use.
4
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
3
Install the dust nozzle on the tool using the screw.
6 5
► 1 . Dust nozzle 2. Screw
4
Connect a hose of the vacuum cleaner to the dust noz-
3 zle using the front cuff 24 (optional accessory).
► 1 . Dust nozzle 2. Front cuff 24 3. Hose of the vac-
14 ENGLISH
Loosen the lever on the depth guide and move the
Press the shaft lock fully so that the mounting
Install outer flange and hex bolt again. Press the
Connecting a vacuum cleaner
Fig.24
1 2
Fig.25
uum cleaner
1
2
3