Precautions For Installing Batteries - Kamada power KMDPJ24100 User Manual

3.3.1 lnstallation steps
Assembly and
commissioning
step number
step 1 Fixed expansion screw
step 2 Wall mounted battery
Pair plugging positive and
step 3
negative power cables
Docking inverter and battery
step 4
communication cable
step 5 Dial the ADD address switch
step 6 turn on the switch

3.4.1 Precautions for Installing Batteries

（KMD-PJ Series）
Name
a. Fasten the expansion screw to the load-bearing wall
b. Fasten the battery to the expansion screw
c.Insert the positive and negative power cord pairs between the
battery and the inverter
d.According to the communication protocol port of the inverter,
one end of the communication line between the inverter and the
battery is plugged into the CAN or RS485 port of the battery,
and the other end is plugged into the inverter.
e.If it is a battery, dial 1, and the rules of other dialing addresses
are detailed in the attached page.
f.Press the power switch on the side to let the ON/OFF RUN 6
battery indicator lights display in green
Before choosing an installation location, consider the following:
Assembly Instructions
Install the machine
Do not install the battery on flammable building
1
materials
2 Mount on a solid wall
Install this inverter at eye level to read the LCD display
3
at all times
To ensure optimum operation, the ambient
4 temperature should be between 0 ° C and 55 ° C.
Vertical wall installation is recommended
Make sure there is a certain amount of free space
around the inverter, as shown on the right, to ensure
5
adequate heat dissipation and enough room to move
the wires.
Suitable for installation on concrete or other non-combustible surfaces
11