Power; Data Connections - Cisco Catalyst CG113-4GW6 Hardware Installation Manual

Install Cisco Catalyst Wireless Gateways
Required Equipment
Small Phillips-head screwdriver
Install SIMs
1. On the bottom of the Cisco Catalyst Wireless Gateway, open the cover for the SIM slots using the a small
Phillips-head screwdriver.
2. Install either one (1) or two (2) SIM cards in the two slots, marked 0 and 1.
If you are installing two SIM cards, make note of which SIM card you place in each slot. This information
is required during configuration of the two slots as primary and secondary.
3. Replace the cover for the SIM slots.

Power

Connect the power adapter to an household power outlet, and connect its cable to the USB-C port on the back
of the Cisco Catalyst Wireless Gateway.
Ensure that the power cable is properly secured.

Data Connections

Ensure that any data cables connected to the device are properly secured.
Table 11: Data Connections
Connection
Internet
Description
Connect the device to a WAN providing internet access, using the 2.5 Gbps
ethernet interface.
Hardware Installation Guide for Cisco Catalyst Wireless Gateways
Power
21