Table of Contents
Advertisement
en Time-setting options
When the operation has ended, remove the food
7.
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
9 Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
9.1 Setting the cooking time
You can set the cooking time for the operation of up to
24 hours.
Requirement: An operating mode and temperature or
setting have been set.
Press "Cooking time".
1.
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "min."
a The selected value is marked in blue.
Set the cooking time using
3.
adjustment bar.
If required, use
to reset the adjustment value.
Press "Apply".
4.
Use
to start the operation.
5.
a The appliance starts to heat and the time counts
down.
a Once the cooking time has elapsed, a signal tone
sounds. A note appears on the display confirming
that the operation has finished.
Once the cooking time has elapsed:
6.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the cooking time
You can change the cooking time at any time.
Press the cooking time.
1.
Change the cooking time using
2.
via the adjustment bar.
Press "Apply".
3.
Cancelling the cooking time
You can cancel the cooking time at any time.
Press the cooking time.
1.
12
or
or directly via the
to switch the ap-
or
, or directly
Note: If necessary, change the basic setting for the
lighting again.
Reset the cooking time using
2.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
Press "Apply".
3.
9.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Notes
¡ To achieve good cooking results, do not delay the
time once the operation has already started.
¡ Food will spoil if you leave it in the cooking com-
partment for too long.
Requirements
¡ An operating mode and temperature or level have
been set.
¡ A cooking time is set.
Press "End time".
1.
Use
or
to delay the time.
2.
If required, use
to reset the setting value.
Press "Apply".
3.
Press
to start the operation.
4.
a The display shows the start time. The appliance is in
standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
5.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Setting the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press "End time".
1.
Use
or
to change the time.
2.
3.
Press "Apply".
Cancelling the end time
You can delete the set time at any time.
Press "Stop"
1.
Press "End time"
2.
Use
to reset the time.
3.
Note: For operating modes that always require a
cooking time, the appliance resets the time at which
the cooking time ends to the next possible time.
Press "Start"
4.
.
to switch the ap-
Advertisement
Table of Contents
