Chapter 2: Preparing The Device Being Removed - Canon FedEx Office imagePRESS C750 Configuration And Installation Manual

Chapter 2: Preparing the Device Being Removed

NOTE: If there are no Canon devices being removed, proceed to Chapter 3.
Two steps are required before beginning installation of the imagePRESS C750
 Secure a Fiery Configuration Page from the devices that are being removed. Make
note of the IP address of the device being removed, as the device being installed will
use the same IP address.
 Erase customer data from the Fiery and imageRUNNER ADVANCE Hard Disk
Drives.
1. Securing a Fiery Configuration Page (IP Address Information)
FedEx Office is redeploying IP addresses under a new network scheme. As a result
it is not possible at the writing of this document to identify the IP address information
needed to complete an installation correctly. The best process to use under these
circumstances is print a Fiery Configuration Page to capture the IP addresses of the
devices that are being replaced, and to provide this information to the installing
Technician for use when installing the replacement device(s).
Printing a Fiery Configuration Page
a. From the engine control panel, press Main Menu button. If the Fiery icon does
not appear on the copier's touch panel, press [Show All].
b. From the copier's touch panel, select the Fiery Button > Info > Print pages >
Configuration > Yes.
Wait for the Configuration pages to print.
2. Performing a Clear Server on the Fiery
Before the device is removed from the Center, the imagePASS HDD needs to have
all the jobs deleted. This is done at the engine UI with the following steps:
a. Select [Show All].
b. Select [Printer].
c. Select [Run Setup]. (This will take approximately 2 minutes then a login will
appear.)
d. Enter the password Fiery.1.
e. Scroll to page 2, and then select [Clear Server].
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide 6