Chapter 6: Imagepress Server G100 Set-Up - Canon FedEx Office imagePRESS C750 Configuration And Installation Manual

Chapter 6: imagePRESS Server G100 Set-up

This section will guide you through the setup of the imagePRESS Server G100 to meet
the FXO Standard configuration. All files for this section can be obtained from the
Canon e-Support site under the Major Accounts section > New MFP Deployment.
Note: A reference configuration page with highlighted yellow sections showing FedEx
Office settings is included at the end of this document. It can be used to compare the
configuration after engine and controller setup is completed.
Note: The IP address obtained in Chapter 5 will be used to configure the controller.
The Subnet mask and gateway will be identical to the machine being replaced.
.
Preparing the USB drive for the FedEx Office Clone image
Note: It is strongly recommended that you prepare the USB drive before going on
site to do the installation.
Before you begin, please make sure you have the following items:
 USB Drive (Minimum 16 GB) – not provided
All items below are downloaded from the Canon USA FedEx Office e-Support
Major Account Site
 Fiery USB Setup tool for System Software
FieryUSBSetupTool_v2.0.21.zip
 Fiery Clone Tool v2.3 for FXO
FCTe-2.3.iso.zip
 FXO imagePRESS Server G100 Clone Image File
FXO_C750_G100_Clone_08_29_2019.zip
 Updated Paper Catalog
FXO_C750_G100_Paper_Catalog_06-10-2020.zip
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide 21