Installing The Head Protectors; Mounting The Push Handle - QERIDOO Kidgoo1 2019 User Manual

Assembly
Slide the leaf spring cover onto the slide holder as shown
f
in the picture.
Be sure that the fixing mechanism locks audibly.
f
Repeat the procedure on the other side of the trailer.
f

Installing the head protectors

The head protectors serve as additional side protection in case the trailer should tip over.
Slide the head protector onto the slide holder as shown in
f
the picture.
Be sure that the fixing mechanism locks audibly.
f
Repeat the procedure on the other side of the trailer.
f

Mounting the push handle

The push handle has multiple height settings and is used for pushing, pulling and manoeuvring your
Kidgoo. And if it becomes necessary, it performs an important safety function as a impact protection.
The push handle is attached at the top of the cabin frame using 2 connecting screws:
Unfold the push handle completely. To do this, keep the light grey pushbuttons pressed on both
f
sides, see „Adjusting the push handle" on
Use two hex keys to loosen and remove the two pre-as-
f
sembled screws.
Hook the upper loops of the canopy into the tube ends at
f
the cabin roof.
Insert the two ends of the push handle into the tube ends
f
at the cabin roof.
First, insert one part of the two-piece connecting screw
f
into the opening of the push handle and lock it with a hex
key.
Insert the second part of the connecting screw into the
f
opposite opening and tighten it firmly with the second
hex key.
Repeat the procedure on the other side.
f
Danger!
Make sure that the push handle is also mounted for every journey in Trailer mode. Only then
does the cabin have an impact protection.
14 – 06|2019 – Subject to change.
page 21.
Kidgoo 2019