Table of Contents
Advertisement
• This set can be disassemble in the order shown below.
Set
Lid, Battery Case
"Knob (Tuning)", "Knob (Volume)"
Chassis Section
Note: Follow the disassembly procedure in the numerical order given.
LID, BATTERY CASE
"KNOB (TUNING)", "KNOB (VOLUME)"
Note: Insert the knob (volume) into
the variable resistor (RV1),
meeting both shapes of the hole
in the knob and the shaft of RV1 as shown.
variable resistor (RV1)
hole
SECTION 2
DISASSEMBLY
"Antenna, Telescopic (FM/SW) (ANT1)", "Cabinet (Rear)"
Main Board
Antenna, Ferrite-Red (MW) (L1)
Speaker (9.2 cm) (SP1)
1 Open the battery case lid.
2 boss
knob (volume)
– 3 –
Chassis
2 boss
3 lid, battery case
2 tuning, spring
5 O ring, P-9
6 knob (volume)
3 knob (tuning)
1
4
Advertisement
Table of Contents
