Table of Contents
Advertisement
After a few seconds, the cooking time begins to elapse.
Note: The same cooking time can be automatically
programmed for the all the hotplates. The programmed time
passes independently for each of the hotplates.
The Basic settings chapter provides information on
automatically programming the cooking time.
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Changing or cancelling the time
Press the
0
symbol several times until the required
indicator lights up. Change the cooking time in the
programming panel, or set to
Once the time has elapsed
The hotplate switches off. An audible signal sounds and
appears in the time program function display for 10 seconds.
The
indicator lights up. Pressing the
x
indicators and stops the signal.
Automatically switch off a hotplate with the deep-frying
function
When cooking using the deep-frying function, the programmed
cooking time begins to count down once the selected hotplate
reaches the desired temperature.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
symbol. A signal sounds. The control panel is
#
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note: The lock does not affect the main switch. The hob may
be switched off when desired.
x
.
‹‹
symbol turns off the
0
and
"
Notes
If a cooking time has been programmed in several zones, it
■
can be set to display all time values. To do this, press the
symbol several times until the
hotplate lights up.
Cooking times of up to 99 minutes can be programmed.
■
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
Programming
Press the
0
1.
up.
lights up in the time program function display.
‹‹
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
symbol several times until the
0
up. Change the cooking time in the programming panel, or set
to
.
‹‹
‹‹
Once the time has elapsed
A warning beep sounds. In the time program function display
is shown, and the
‹‹
the indicators turn off.
Pressing the
0
beep.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
‰
indicator for the required
x
symbol several times until the
indicator comes on. After 10 seconds
W
symbol turns off the indicators and stops the
0
W
indicator lights
indicator lights
W
13
Advertisement
Table of Contents
