Table of Contents
Advertisement
Powerboost function
The Powerboost function can be used to heat large amounts of
water more quickly than the power level
Limitation on use
This function is available on all hotplates, provided that no other
hotplate in the same group is operating, (see picture). If this is
not the case, the
and
›
Š
hotplate display; then it will automatically set the power level
In group 2, the powerboost function may be activated at the
same time for all hotplates (see picture).
*URXS
Time programming function
This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■
Turning off a hotplate automatically
Enter the cooking time for the required hotplate. The hotplate
turns off automatically once the time has elapsed.
How to program
Select the required power level.
1.
Press the
symbol. The
0
2.
up.
is displayed in the time program function display. To
‹‹
select another hotplate, press the
until the
indicator for the desired hotplate lights up.
x
Select the required cooking time in the programming panel.
3.
The possible previous setting is, from left to right 1, 2, 3, etc.,
up to 10 minutes. Within the next 10 seconds, continue
passing through the options in the programming panel until
reaching the desired time.
After a few seconds, the cooking time begins to count down.
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
12
.
Š
symbols will flash on the selected
*URXS
*URXS
indicator of the hotplate lights
x
symbol several times
0
To activate
Select the power level
1.
Press the programming panel located above the
2.
The function has been activated.
To turn off
.
Press the programming panel located above the
Š
The Powerboost function has been deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Once the time has elapsed
The hotplate switches off. An audible signal sounds and
appears in the time program function display for 10 seconds.
The
indicator lights up. Pressing the
x
indicators and stops the signal.
Changing or cancelling the time
Press the
symbol several times until the desired
0
lights up. Change the cooking time in the programming panel,
or set to
.
‹‹
Automatically switch off a hotplate with the deep-frying
function
When cooking using the deep-frying function, the programmed
cooking time begins to count down once the selected hotplate
reaches the desired temperature.
Notes
If a cooking time has been programmed in several zones, it
■
can be set to display all time values. To do this, press the
symbol several times until the
hotplate lights up.
Cooking times of up to 99 minutes can be programmed.
■
Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a zone may be cancelled or
changed:
Press the
symbol several times until the required
0
indicator lights up. Change the cooking time in the
programming panel, or set to
.
Š
@›
symbol turns off the
0
indicator for the required
x
.
‹‹
symbol.
@›
symbol.
‹‹
indicator
x
0
x
Advertisement
Table of Contents
