Garland GEISER 281 G Instruction Manual page 27

6. If the engine does not start, move
the air lever to open and pull the
starter rope until the engine
starts "open".
7. If the engine does not start, move
the air lever to open and pull the starter rope until
the engine starts.
8. Regulate the accelerator so that the engine moves
at the desired speed.
6.4.4. HOT START UP
1. Place the switch in the ¨I¨ position.
2. Put the air lever in the open position
3. Place the accelerator lever at 50%.
4. Pull the starter rope until the engine starts holding
the machine firmly to the ground by the handle.
5. Regulate the accelerator so that the engine moves
at the desired speed.
6.4.5. ENGINE STOPAGE
1. Move the accelerator lever to its minimum.
2. Place the switch in the ¨O¨ position (stoppage)
3. Close the petrol key.
6.5. CHECKING POINTS AFTER START UP
Check that the pump sucks up water. Make sure that
there are no air leakages in the hose.
Check that all the racors are correctly tightened and
that there are no water leakages on the main body of
the pump, through the racors or in the impulsion hose.
Attention! If you observe that water does not
reach the pump in a short interval of time, stop the
pump to avoid breakages.
Attention! Do not fill the pump with water with
the pump running.
6.6. END OF USAGE
After using the machine, empty the water that is
inside the machine. To do this, unscrew the emptying
water screw and wait for the water to empty from the
machine. After this, screw back into place.
7. MAINTENANCE AND SERVICE
The objective of the maintenance and service is to
.
ensure that your machine works always in the best
possible conditions both in efficiency and security.
Follow the recommendations and the maintenance
periods included in this manual.
Turn off the engine before doing any
adjustments, change of accessories or storing the
machine.
Warning! Do not modify the machine. An
inadequate use of these elements can cause
PERSONAL DAMAGES AND EVEN DEATH.
Maintain the machine clean, specially the petrol
deposit area and the area near the air filter.
Any changes should be done on a flat and stable surface.
Only use original spare parts and accessories for this
machine so as to obtain the best performance from
the machine. These spare parts and accessories can
be found in the official distributors of the brand.
The use of other spare parts and accessories could
result in risks to the end user, people who are nearby
and to the machine.
27/100
English