Firmware Version; Firmware Upgrade; Mdc Card Upgrade; Bluos Setup - NAD C368 Owner's Manual

FIRMWARE VERSION

Source Setup
Firmware Version
Main:Vx.xx
VFD :Vx.xx
BT :Vx.xx
Firmware version details of Main (MCU), VFD (display) and BT (Bluetooth)
are displayed. "x.xx" above stands for the version number of the particular
firmware item.

FIRMWARE UPGRADE

Source Setup
Firmware Upgrade
VFD Upgrade
Select Firmware Upgrade to initiate VFD Upgrade or BT Upgrade. At each
upgrade mode, select "Yes" to start upgrade process or "No" to retain current
firmware.

MDC CARD UPGRADE

Source Setup
MDC Card Upgrade
Slot:2 BluOS
MDC CARD UPGRADE identifies and shows the MDC modules installed at
the MDC slots in the rear panel.
A software upgrade of an installed MDC module like the DD USB 2.0 can
be initiated via the MDC Card Upgrade menu. Upgrade the installed DD
USB 2.0 by complying with the DD USB 2.0 software upgrade guideline that
comes with the software upgrade file.
NOTE
An installed MDC BluOS module cannot be upgraded in this menu. MDC
BluOS module upgrade can be facilitated via the BluOS app or "BluOS
Setup" menu.

BLUOS SETUP

Settings Settings Source Setup
"BluOS Setup" becomes available as one of the Main menu items when an
optional MDC BluOS module is installed in one of the MDC slots in the rear
panel. The following are the BluOS Setup menu options.
IMPORTANT NOTE
The BluOS Setup menu options can be configured only at BluOS source
Settings Settings
mode. With other sources, the BluOS Setup menu options can be viewed
only but not configurable.
INFO
Display MAC address, IP address, BluOS version and other related
information about the installed MDC BluOS module.
BluOS REBOOT
Yes: Restart MDC BluOS module.
No: Maintain current settings.
SERVICE MENU
Settings Settings
There are two options for Service Menu – BluOS Upgrade and BluOS
Service.
BluOS Upgrade
Ensure that the MDC BluOS is connected wired or wirelessly.
BluOS Service
Use for servicing purposes only. This is a feature normally associated
and coordinated with authorized service personnel.
BluOS RESET
Initiate the restoration of the MDC BluOS to its factory default settings.
Yes: Initiate factory reset.
No: Maintain current settings.
Settings
BluOs
-20.0 dB
Yes: Initiate BluOS upgrade mode. Upgrade mode will proceed
automatically.
No: Maintain current settings.
Yes: Activate Service mode. This must be coordinated or
performed by authorized service personnel.
No: Maintain current settings.
OPERATION
USING THE C 368
BluOS Setup
19