Kenwood TH-D75A User Manual page 11

[MR] (2)
Press [MR] to enter Memory Channel mode.
Press [F], [MR] to move to the Memory channel store
screen.
[CALL] (3)
Press [CALL] to select the Call channel.
Press [F], [CALL] to store the current operating frequency
to the Call channel.
[MSG] (4)
Press [MSG] to display the APRS Message list.
Press [F], [MSG] to enter the New Message input mode.
[LIST] (5)
Press [LIST] to display the APRS Station list.
• Each time you press [F], [LIST], the mode cycles
through the following: APRS mode ON  KISS mode
ON  OFF.
[BCN] (6)
Press [BCN] to transmit the beacon when APRS mode is
ON.
Press [F], [BCN] to transmit the Object.
[REV] (7)
Press [REV] to turn the Reverse function ON or OFF.
Press [F], [REV] to select the Shift direction.
[TONE] (8)
Press [TONE] to turn the Tone function ON.
• Each time you press [TONE], the function cycles
through the following: Tone ON  CTCSS ON  DCS
ON  Cross Tone ON  OFF.
Press [F], [TONE] to enter the Tone frequency, CTCSS
frequency, DCS code, or Cross Tone setup mode.
Press [F], [TONE] (1s) to start the Tone frequency, CTCSS
frequency, or DCS code scan.
[PF1] (9)
Press [PF1] to activate its programmed function.
Press [F], [PF1] to turn the Attenuator function ON or OFF.
[MARK] (0)
Press [MARK] to display the Position memory list.
Press [MARK] (1s) to enter the Mark Way point registration
mode.
Press [F], [MARK] display your "My position".
[MHz] ( )
Press [MHz] to enter the MHz mode.
Press [MHz] (1s) to start the MHz scan.
Press [F], [MHz] to enter Fine tuning function mode.
[PF2] (#)
Press [PF2] to activate its programmed function.
Press [F], [PF2] to enter Frequency step setup mode or
Fine step frequency setup mode.
ON AIR/ Busy Indicator
The indicator lights red in transmitting, and lights green in
receiving.
The indicator lights blue in transmitting in the reflector
terminal mode.
GETTING ACQUAINTED
9