Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Light Kit Screw
bag
Socket
Glass
Lift the glass assembly until its screw holes
are aligned with the screw holes in one
of the sockets of the light kit assembly.
Secure with the three light kit screws found
in the
hardware bag.
Repeat x3
Ceiling Bracket
Downrod
Assembling the Light
2
2 of 3
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Installing the Bulbs and Glass
9 of 12
Note:
Fan style may vary.
Hanging Fan
Wiring
Note:
Fan style may vary.
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
Canopy
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
bag
Install the three light kit screws found in
the
hardware bag.
IMPORTANT
NOTE: Blades will need to be rotated to access all
screw holes.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 3
Light Kit Screw
3 of 12
Light Kit Screw
ON
8
Glass/Bulbs
Advertisement
Table of Contents
