Sony MHC-GN660 Operating Instructions Manual page 17

7
Repeat steps 1 to 6 to store other
stations.
Other operations
To Do this
Tune in a station Follow the procedure described
with a weak signal in "Manual tuning preset".
Set another station Start over from step 1.
to the existing
preset number
To improve tuner reception
When tuner reception is poor, set the CD power
manage function to "CD POWER OFF". The
default setting is "CD POWER ON".
Use buttons on the system for the operation.
1
Press CD.
2
Press ?/1 to turn off the system.
3
Press ?/1 while holding x.
"CD POWER OFF" appears in the display.
To set CD power on
Repeat the procedure above and "CD POWER
ON" appears in the display.
Notes
• When "CD POWER OFF" is selected, CD access
time is increased.
• You cannot change the CD power management
setting in the Power Saving Mode (page 29).
To change the AM tuning interval
(except for Middle Eastern
models)
Use buttons on the system for the operation.
The factory settings for AM tuning interval is
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, press ?/1. When you change the
interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode (page 29).
Tips
• The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
• If you press TUNER/BAND while the power is off,
the power turns on automatically and TUNER is
selected as a function.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
• You can also press FUNCTION repeatedly on the
remote to select "TUNER".
17 GB