Zanussi ZDLN7531 User Manual page 17

3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the lid locks
into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
The upper ends of the two vertical ribs
inside the compartment (B) indicate the
maximum level for filling the dispenser
with gel (max. 30ml).
9.2 How to select and start a
programme
1. Press the button dedicated to the
programme you want to set.
• The light related to the button is on.
• The display shows the programme
duration.
2. Activate applicable options if desired.
3. Close the appliance door to start the
programme.
9.3 How to select and start the
programme Pre-rinse
1. To select Pre-rinse, press and hold 30
min for 3 seconds.
• The light related to the button is on.
• The display shows the programme
duration.
Options are not applicable to this
programme.
2. Close the appliance door to start the
programme.
9.4 How to activate options
1. Select a programme.
2. Press the button dedicated to the option
you want to activate.
• The light related to the button is on.
• The display shows the updated
programme duration.
By default, options must be activated
every time before you start a programme.
If the latest programme selection is
enabled, the saved options are activated
automatically along with the programme.
It is not possible to activate or deactivate
options while a programme is running.
Not all options are compatible with each
other.
Activating options often increases the
water and energy consumption as well as
the programme duration.
9.5 How to select and start the
programme AUTO
1. Press AUTO.
• The light related to the button is on.
• The display shows the programme
duration.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and
adjusts a suitable wash cycle. During the
cycle, the sensors operate several times and
the initial programme duration can decrease.
9.6 How to delay the start of a
programme
1. Select a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1 to
24 hours).
The light related to the button is on.
3. Close the appliance door to start the
countdown.
ENGLISH 17