Advertisement
SHARPENING
OR REPLACING
CHIPPER
BLADES
•
Disconnect the spark plug wire and move wire away
from the spark plug.
Remove the access plate by removing two hex lock
nuts. See figure 30.
Locate one of the chipper blades in the access plate
opening by rotating the impeller assembly by hand.
Remove the blade using a 3/16" allen wrench on
the outside of the blade and a 1/2" wrench on the
impeller assembly', inside the housing.
Remove the other blade in the same manner.
Replace or sharpen blades. If sharpening, make
certain to remove an equal amount from each blade.
Reassemble in reverse order.
NYLOCK NUTS
ACCESS
PLATE
c-_
................
c ...............
NOTE: Make certain the blades are reassembled with
the sharp edge facing upward, as viewed from the access
plate opening.
FIGURE
30
Clean the engine and the entire unit thoroughly.
Refer to engine manual for correct engine storage
instructions.
If storing in an unventilated or metal storage shed, coat
metal parts with light oil or silicone to prevent rust.
Store unit in a clean, dry area.
Call 1-866-576-8388
for missing parts or assembly help
1 9
DO NOT RETURN TO STORE
Advertisement
