Makita LS001G Instruction Manual page 20

For tool with the inner flange for
15.88 mm hole-diameter saw blade
Country specific
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place circu-
lar saw blade (with the ring attached if needed), outer
flange and hex bolt.
For tool without the ring
2
1
4
► 1. Outer flange 2. Circular saw blade 3. Inner flange
4. Hex socket bolt (left-handed) 5. Spindle
For tool with the ring
2
1
4
5
► 1. Outer flange 2. Circular saw blade 3. Inner flange
4. Hex socket bolt (left-handed) 5. Ring 6. Spindle
WARNING:
If the ring is needed to mount
the circular saw blade onto the spindle, always
be sure that the correct ring for the circular saw
blade's arbor hole you intend to use is installed
between the inner and the outer flanges. Use
of the incorrect arbor hole ring may result in the
improper mounting of the circular saw blade causing
blade movement and severe vibration resulting in
possible loss of control during operation and in seri-
ous personal injury.
For tool with the inner flange for
other than 20 mm or 15.88 mm hole-
diameter saw blade
Country specific
The inner flange has a certain diameter of a blade mounting
part on one side of it and a different diameter of blade mount-
ing part on the other side. Choose a correct side on which
blade mounting part fits into the saw blade hole perfectly.
3
5
► 1. Outer flange 2. Circular saw blade 3. Inner flange
4. Hex socket bolt (left-handed) 5. Spindle 6. Blade
mounting part
CAUTION:
part "a" on the inner flange that is positioned
3
outside fits into the circular saw blade hole "a"
perfectly. Mounting the circular saw blade on the
wrong side can result in the dangerous vibration.
Connecting a vacuum cleaner
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner.
6
Dust bag
CAUTION:
attach the dust bag or connect a vacuum cleaner
to prevent dust-related hazards.
The use of the dust bag makes cutting operations
cleaner and dust collection easier.
To attach the dust bag, fit it onto the dust nozzle.
To attach the fastener, align the top end of the fastener
with the triangular mark on the dust bag.
20 ENGLISH
2
1
4
Make sure that the blade mounting
When performing a cutting, always
3
5
6