Russound AW70V6mk2 Installation Manual page 8

INSTALLING THE BRACKET ON POLE
Installing the mounting bracket on a pole
The speaker can be installed horizontally or vertically on a pole
with up to 1" (2.54 cm) inner diameter with two standard 5/16
x 1-3/8 x 1/2" U-bolts with 5/16-18" threads. For a horizontal
installation, install the mounting bracket with its end "C" slots
at the top. Also, when installing the speaker outdoors in the
horizontal position, locate the mounting bracket high enough
so the front of the speaker will point down toward the listening
area.
Installation on pole
1. Pass two standard U-bolts behind the pole and slide bracket
over ends.
2. Attach bracket with lock washers and bolts, and tighten.
Installation on in-ground pole
The speaker can be mounted on an in-ground pole with buried
cable. First, consult your local utility companies to learn of
existing buried cables, pipes or lines. Be aware of any local
building code requirements that may be applicable.
1. Drive a 1" (2.54 cm) pipe into the ground at the pre-qualified
location. Determine the length and location for the cable
trench and dig below the frost line. Use either direct buried
speaker cable or cable run through conduit.
2. Pass two standard U-bolts behind the pole and slide bracket
over ends.
3. Attach bracket with lock washers and bolts, and tighten.
4. Leave about 2 feet of cable at the speaker end for
connections and adjustments.
8 Russound AW70V6mk2 70V Surface Mount Indoor/Outdoor Speaker Installation Manual
Mounting bracket horizontal position
Mounting bracket vertical position