Using The Reset Button - Cisco 2504 Getting Started Manual

With Release 7.4, directly connected local mode APs via two PoE (Power over Ethernet) ports are
Note
supported. Directly connected APs were not supported before Release 7.4.
You have prepared the controller for basic operation. Refer to the
Configuration Guide
wireless network.
Figure 14
Checking the Controller LEDs
If your 2504 controller is not working properly, check the LEDs on the front panel of the unit. You can
use the LED indications to quickly assess the status of the unit. See
of the front panel LEDs.
The installation is complete. Refer to the Cisco Wireless Controller Configuration Guide for more
information about configuring your controller. The guide is available on cisco.com.

Using the Reset Button

The Reset button on the front panel of the controller becomes active after the controller boots. To reset
the controller using the Reset button, follow these steps:
Connect a PC to the controller console point.
Step 1
Press and hold the Reset button for at least 3 seconds using a pointed object, such as a ball point pen,
Step 2
pencil, or paper clip.
for information on configuring the controller to meet the specific needs of your
Access Points Connected to a Controller
Cisco 2504 Wireless
Controller
Cisco Access Points
Cisco 2500 Series Wireless Controller Getting Started Guide
Cisco Wireless Controller
Network
10/100/1000BASE-T
MDI cable
Network
10/100/1000BASE-T
MDI cables
Table 1 on page 4
Connecting to the Network
for a description
29