Your Clié Handheld Does Not Operate Properly; You Cannot Turn On Your Clié Handheld; The Screen Is Not Displayed Though The Power Led Is On; No Response To Operations - Sony CLIE PEG-NX70V Frequently Asked Questions Manual

Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Your CLIÉ Handheld does not operate
properly
You cannot turn on your CLIÉ handheld
B The HOLD switch of your CLIÉ handheld is on.
Your CLIÉ handheld will not operate when the HOLD switch is on. Make
sure that the HOLD switch is off.
B The battery has run out.
Connect your CLIÉ handheld to the adapter with the cradle and turn on
your CLIÉ handheld after a few minutes. When your CLIÉ handheld turns
on, charge it. When the battery charge is done, perform a soft reset. (The
battery charge takes more than four hours normally.)
B The connector between your CLIÉ handheld and the cradle is dirty.
You cannot recharge your CLIÉ handheld if the connector is dirty. Try
re-installing your CLIÉ handheld several times in the cradle to clean the
connector.

The screen is not displayed though the POWER LED is on

B The HOLD switch of your CLIÉ handheld is on.
The screen will not be displayed when the HOLD switch is on
B Perform a soft reset by pressing the reset button.
b
For details, refer to "Basic operations of your Sony CLIÉ™ Handheld: Resetting
your Sony CLIÉ Handheld" in "Read This First (Operating Instructions)."

No response to operations

B The HOLD switch of your CLIÉ handheld is on.
Your CLIÉ handheld will not operate when the HOLD switch is on. Make
sure that the HOLD switch is off.
Continued on next page
• • • • • • • • • • • • • • • • • • • • • • • • •
13