Table of Contents
Advertisement
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
"Auto" uses default value: for a Root port it is 100ms, for a Hub port the delay is taken from Hub
descriptor.
Options: Auto (Default) / Manual
Note
» The following items appear only when you set the Device power-up delay function to [Manual].
Device power-up delay in seconds
Delay range is 1 ~ 40 seconds, in one second increments.
Options: 5 (Default)
USB FLASH DRIVE PMAP
This item Mass storage device emulation type. 'AUTO' enumerates devices according to their
media format. Optical drives are emulated as 'CDROM' , drives with no media will be emulated
according to a drive type.
Options: Auto (Default) / Floppy / Forced FDD / Hard Disk / CD-ROM
CPU Configuration
This item shows CPU Information
C6DRAM
This item enables or disables moving of DRAM contents to PRM memory when CPU is in C6 state.
Options: Disabled (Default) / Enabled
Overclocking Lock
This item enables or disables Overclocking Lock (BIT 20) in FLEX_RATIO(194) MSR.
Options: Disabled (Default) / Enabled
Hardware Prefetcher
This item to turn on / off the MLC streamer prefetcher.
Options: Enabled (Default) / Disabled
Z270GTN / B250GTN
2. Advanced Menu | 15
Advertisement
Table of Contents
