Biostar Z490T-SILVER Manual page 12

Step 1: Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the slot
such that the notch on the DIMM matches the break on the slot.
Step 2: Insert the DIMM vertically and firmly into the slot until the retaining clips snap back in
place and the DIMM is properly seated.
Note
» If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again.
Memory Capacity
DIMM Socket Location
DIMMA0
DIMMB0
Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
Disabled
Disabled
Enabled
(O means memory installed, X means memory not installed.)
Note
» When installing more than one memory module, we recommend to use the same brand and
capacity memory on this motherboard.
12 | Chapter 2: Hardware installation
DDR4 Module
4GB/8GB/16GB/32GB
4GB/8GB/16GB/32GB
DIMMA0 DIMMB0
X O
O X
O O
Total Memory Size
Max is 64GB.