Cables And Accessories - National Instruments NI 781 R Series User Manual

Chapter 1 Introduction

Cables and Accessories

Cable
*
SHC68-68-RMIO
(NI Recommended)
SHC68-68-RDIO
(NI Recommended)
SH68-C68-S
CAT 5 Ethernet
*
crossover cable
*
NI 783xR/784xR/785xR devices only.
†
For a diagram of the twisted pairs in the SHC68-68-RMIO and SHC68-68-RDIO cables and the signals to which they
correspond, go to
ni.com/info
R Series Intelligent DAQ User Manual
National Instruments offers a variety of products you can use with R Series
devices, including cables, connector blocks, and other accessories,
as shown in Table 1-3.
Table 1-3. R Series Connectivity Options
Connector Accessory
0 NI SCB-68
1, 2 NI SCB-68
0, 1, 2 NI SCB-68
— —
and enter the info code
Refer to Appendix A,
about using these cables and accessories to connect I/O signals to the
NI 78xxR. Refer to
ni.com/products
to you for the most current cabling options.
High-performance shielded cable wired
specifically for signal connection from
the RMIO connector
terminal block to provide higher signal
integrity and noise immunity.
High-performance shielded cable wired
specifically for signal connection from the
RDIO connector
terminal block to provide higher signal
integrity and noise immunity.
Basic shielded cable for signal connection
from the RMIO or RDIO connector to the
NI SCB-68 terminal block for noise
reduction.
For use with the NI PXI-78xxR running
the LabVIEW Real-Time Module, if the
real-time PXI system is not configured on
a network. To connect the PXI system to
a network port, use a standard CAT 5
10/100Base-T Ethernet cable.
.
rdrmio
Connecting I/O Signals, for more information
or contact the sales office nearest
1-8
Description
†
to the NI SCB-68
†
to the NI SCB-68
ni.com