Table of Contents
Advertisement
Installation Instructions
■
Connecting the water supply hose
The dryer must be connected to the cold water tap using the new water supply hose. Do
not use old hoses.
NOTE
• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm
• Do not strip or cross-thread when connecting inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device
should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
Periodically inspect and replace hoses if bulges, kinks, cuts, wear or leaks are found.
Short
hose
Y connector
10
Hose
connector
Rubber seal
Y connector
Long
hose
A
Step 1 : Check rubber seal in the inlet
hose.
Two rubber seals are supplied with the
water inlet hoses.
They are used for preventing water leaks.
Make sure the connection to the tap is
sufficiently tight.
Step 2 : Check the installation
environment.
A type
-. When using both washer and dryer with
one water tap.
Assemble Y connector and short hose.
Connect the female part of the short
hose to the water tap.
Connect the male part of Y connector to
the female part of the long hose.
Connect another male part of Y
connector to the female part of the inlet
hose of washer.
B type
-. When using only the dryer from one tap.
Connect the female part of the long
hose to the water tap.
NOTE
B
• After connecting the inlet hose to
water tap, turn on the water tap to
flush out foreign substances (dirt,
sand or sawdust) in the water lines.
Let water drain into a bucket, and
check the water temperature.
2
).
Advertisement
Table of Contents
