Countax B MK4 Series Operator's Manual page 36

PGC Connection
Before attempting to install PGC Net park the
tractor on flat and level ground. Engage parking
brake, disengage engine and remove ignition key.
To connect the Powered Grass Collector (PGC) to
the tractor, ensure that both are on an even surface
with the locking levers on the PGC collector facing
the lift arms on the tractor (fig. 64 & 66).
1 - Remove the PGC belt guard by turning the
fixings and lifting the guard piece (fig.64a).
2 - Lift the seat and the PTO flap so that both are
resting in the upright position (fig. 65).
3 - Move the PGC manually to the tractor; set the
tractor lift arms to the lowest position. This makes
installation easier (fig. 66).
4 - Near the end of each lift arm you will find a
locating lug (fig. 66). Slide the channels (fig. 66 &
67) on either side of the Powered Collector over the
lifting arms and lugs but do not engage the locking
lever yet.
5 - Ensure that the rubber flap (fig. 67) at the
opening of the PGC locates above the connecting
tractor transmission grass deflector (fig.65).
Powered Grass
fig. 64a
Collector Installation
PTO Flap
Transmission Grass Deflector
Locking Lever
Channel
Locking Lever
Channel
Page 36
fig. 64
fig. 65
Seat
fig. 66
Locating Lug
Lift Arm
Locking Clip
fig. 67
Locking Clip
Rubber Flap