Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL 4259729 Operating Instructions Manual

6.4 Clockwise/Counter-clockwise switch
(Fig. 6/Item 7)
•
Change switch position only when the drill is
at a standstill!
•
Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (7):
Direction
Clockwise
(forwards and drill)
Counter-clockwise
(reverse)
6.5 Drill / hammer drill selector switch (Fig. 7/
Item 3)
Change switch position only when the drill is at a
standstill!
Drill
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the ham-
mer drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Tips for working with your hammer drill
6.6.1 Drilling concrete and masonry
•
Switch the Drill/Hammer drill selector switch
(3) to position B (Hammer drill).
•
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
6.6.2 Drilling steel
•
Switch the drill / hammer drill selector switch
(3) to position A (drill).
•
Always use HSS drill bits (HSS = high speed
steel) and a low speed setting for drilling
steel.
•
We recommend that you lubricate the hole
with a suitable cutting fluid to prevent unne-
cessary drill bit wear.
6.6.3 Inserting/ Removing screws
•
Switch the Drill/hammer drill selector switch
(3) to position A (drill)
•
Use a low speed setting
Anleitung_TC_ID_710_E_SPK8.indb 29 Anleitung_TC_ID_710_E_SPK8.indb 29
GB
6.6.4 Starting holes
If you wish to drill a deep hole in a hard material
(such as steel), we recommend that you start the
hole with a smaller drill bit.
6.6.5 Drilling tiles
•
To start the hole, switch the drill / hammer drill
Switch position selector switch (3) to position A (drill).
•
Switch the drill / hammer drill selector switch
Pushed to the right (3) to position B (hammer drill) as soon as the
drill bit has passed through the tiles.
Pushed to the left

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the authorized after-sales
service to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment. En-
sure that no water can seep into the device.
The ingress of water into an electric tool in-
creases the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by an authorized service
agent.
Danger! The carbon brushes should be re-
placed by the authorized service technician.
- 29 -
13.02.2020 07:27:52 13.02.2020 07:27:52