Changing The Communication Bandwidth - Sony IPELA SNC-RZ30N User Manual

7
Set the IP address.
To obtain the IP address automatically from a
DHCP server:
Select Obtain an IP address automatically.
The IP address, Subnet mask and Default gateway
are assigned automatically.
To specify the IP address manually:
Select Use the following IP address, and type the
IP address, Subnet mask and Default gateway in
each box.
Note
When you select Obtain an IP address
automatically, make sure that the DHCP server is
operating on the network.
8
Set the primary DNS server address and, if
necessary, secondary DNS server address.
To obtain the DNS server addresses
automatically:
Select Obtain DNS server address automatically.
To specify the DNS server addresses manually:
Select Use the following DNS server address, and
type the Primary DNS server address and
Secondary DNS server address in each box.
Note
The Third DNS server address and Fourth DNS
server address are invalid for this camera.
9
Set the HTTP port number.
Normally select 80 for the HTTP port number. To
use another port number, select the text box and
type a port number between 1024 and 65535.
10
Type the Administrator name and Administrator
password.
The default settings of both items are "admin."
Note
You cannot change the Administrator name and
Administrator password in this step. To change
these items, see "Setting the User — User setting
Page" on page 27.
11
Confirm that all items are correctly set, then click
OK.
If "Setting OK" is displayed, the IP address is
correctly assigned.
Tip
The factory setting of the camera network is as
follows.
IP address: 192.168.0.100
Subnet mask: 255.0.0.0
Wireless LAN setting
Type: 802.11Ad hoc mode
SSID: snc-rz30
Channel: 11 ch
WEP: Off
IP address: 10.0.0.100
Subnet mask: 255.0.0.0
Changing the Communication
Bandwidth
1
Click the Bandwidth control tab to display the
bandwidth setting window.
The current bandwidth is displayed in Current
bandwidth.
2
Click to select the desired bandwidth from the
Setting bandwidth list box.
3
Type the Administrator name and Administrator
password in each box.
4
Click OK.
If "Setting OK" is displayed, the bandwidth setting
is completed.
Using the Supplied Setup Program
47