Cold Startup Delay Switch; Connectors - Axis Q1604 E User Manual

AXIS Q1604–E Network Camera
Hardware overview
15. Bracket screws (4x)
16. Bracket adapter
17. Network cable (route through wall bracket)
18. Wall bracket
19. Bracket adjustment screw

Cold Startup Delay Switch

The Cold Startup Delay switch, when turned on, controls how the camera restarts after a power cut, when temperatures are below
0 °C (32 °F). The camera is first heated to approximately 0 °C (32 °F) before it initializes. This prevents damage to camera parts
sensitive to sub-zero temperatures.

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A stereo connector must be used for the audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please refer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup
> System Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Connecting to an AXIS Video Hosting System service. See
1 second until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See
about 3 seconds.
• Resetting the product to factory default settings. See
Power connector - 2-pin terminal block for power input.
All manuals and user guides at all-guides.com
7
page 39 . To connect, press and hold the button for about
page 39 . To connect, press and hold the button for
page 45 .