Using the Centillion EtherSpeedII Switch Modules
EtherSpeedII Switch Module Startup Failure
Symptom: All LEDs are solidly lit (do not blink) on the switch module.
To resolve the problem:
Ensure that an MCP module is present and operational with the
1.
appropriate version of software.
•
•
Ensure that all modules in the chassis are firmly seated and that the
2.
retaining screws have been tightened.
Remove and reinsert the failing module.
3.
If the problem persists, contact the nearest Nortel Networks Technical
Solutions Center.
4-2
The EtherSpeedII 10/100BASE-T switch module requires version
4.1.2 software or greater.
The EtherSpeedII 100BASE-FX switch module requires version
4.2.1 software or greater.
Get other manuals https://www.bkmanuals.com
207344-B