Additional Programme Settings26; Speed / Eco Perfect - Bosch WAN Series Instruction Manual And Installation Instructions

Additional programme settings
en
The door will be locked.
The selected number of hours (e.g.
‰ h) is shown in the display panel
and counts down until the wash
programme starts. The duration of
the programme is then displayed.
The programme duration is
Note:
included in the selected "Ready in"
time.
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the Inicio/Pausa A (Start/
1.
Reload) button.
Use the Ready in button to change
2.
the number of hours.
Press the Inicio/Pausa A (Start/
3.
Reload) button.
During the timer count-down you can
add or remove laundry as required.
The length of the programme is
Note:
automatically adjusted when the
programme is running.
Certain factors can affect the
programme length, e.g.:
Programme settings,
■
Detergent dosage (additional rinse
■
cycles if required due to foaming),
Load size/type of textiles (longer
■
washing for higher load and for
textiles which absorb more water),
Imbalances (e. g. due to fitted
■
sheets) are offset with several start-
ups of spin cycles,
Fluctuations in power supply,
■
Water pressure (infeeding speed).
■
26
\
Additional programme
settings
The available settings vary depending
A d d i t i o n a l p r o g r a m m e s e t t i n g s
on the model.
You can find an overview of all settings
available for selection in each
programme on the supplementary sheet
for the operating and installation
instructions.

Speed / Eco Perfect

(G F, Turbo Eco Perfect)
Button with two possible settings for
adapting the selected programme:
SpeedPerfect
■
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected
programme, without the
SpeedPerfect setting.
Do not exceed the maximum
Note:
load.
EcoPerfect
■
Energy-optimised washing by
reducing the temperature and
increasing programme duration
while achieving a washing result that
is consistent with the selected
programme, without the EcoPerfect
setting.
If you press the Speed / Eco Perfect
button once, you select the
SpeedPerfect setting. If you press the
button again, the EcoPerfect setting is
activated. The respective symbol is
shown in the display when the setting is
activated. If you press the button again,
no setting is activated.