22. how to change the water level
You can change the water level by selecting two options.
1. Lo indicate water level 23.8 [KHz]
2. Idd indicate water level 23.5 [KHz]
2. HI indicate water level 23.0 [KHz]
Entering set up mode.
You will see LqC1
Press the Hot button.
Press the Warm or the Cold button until
Press the Start button.
Press the Warm or the Cold button until
Press the Start button.
Press Warm(+) or Cold(-) button and then select
Press the Start button.
The machine sets up the value of water level, then advances to the next process
automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
NOTE
• This function can be set only at the machine. It cannot be managed via the setup card.
(It is not applied in setup card.)
or
or
23.8 [KHz]
23.5 [KHz]
• Coin type – Turn on/off toggle switch.
• Card type – Insert the service card.
• OPL type – Push the Hot button twice.
PROGRAMMING MODE - SETUP MODE
Button
appears in the display.
appears in the display.
23.0 [KHz]
53
Display
One or the other will
display.