Note On Use - Siemens SIMATIC IPC MD-34A Operating Instructions Manual

Safety notes

2.6 Note on use

Damage from condensation
NOTICE
Damage from condensation
If the device has been exposed to low temperatures or extreme temperature fluctuations
during transport, it is possible that moisture has condensed on or inside the device
(condensation).
Moisture can cause short-circuits in electrical circuits and damage the device.
• See the note "Electric shock and fire hazard due to device damage".
• Store the device in a dry place.
• Bring the device to room temperature before commissioning.
• Do not expose the device to direct thermal radiation from a heater.
• If condensation develops, wait approximately 12 hours or until the device is completely
2.6 Note on use
NOTICE
Possible restricted functions in case of non-validated function of the plant.
The device is tested and certified based on the technical standards. In some cases function
restrictions can occur during the operation of your plant.
To avoid restrictions, validate the correct function of the plant.
Note
Ventilation of the device
The device is cooled through several ventilation slots: If the cooling air flow is impeded, the
device may overheat and be damaged.
• Ensure that these ventilation slots are not covered or closed during operation.
• Do not place the device directly next to a wall or in an enclosed space.
Note
Requirements for base on which device is operated
Avoid any damage to the device from scratching or overheating.
Only place the device on a flat, even, clean and hard base.
22
dry before switching it on.
Operating Instructions, 08/2023, A5E52427535-AA
MD-34A