User's Manual
INSTALLATION INSTRUCTIONS
INSTALL
REMOVE
Figure.1. Installing and Removing the Base
INSTALLATION:
1. Monitor and the Arm alignment, Insert the Monitor port.
2. Install the Arm on Monitor with Two screws.
3. Align the monitor with the opening in the base.
4. Install the base on Arm with One screws.
REMOVAL:
1. Remove the screws so that the stand base can be removed.
2. Gently pull the base from the monitor until they are unattached.
3. Remove the screws so that the stand Arm can be removed.
4. Then gently remove the stand Arm.
Warm prompt: Place the Monitor face down on a soft and flat surface (blanket, foam, cloth, etc) to
Monitor while install and remove.
POWER
POWER SOURCE:
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an Internal universal power supply that allows operation in either
100/120V AC or 220/240V AC voltage area (No user adjustment is required.)
3. Connect the AC-power cord one end to your LCD monitor's AC-input socket, the other end to
wall-outlet.
8