3.5-Inch Hard-Drive Cage; Removing The 3.5-Inch Hard-Drive Cage; Installing The 3.5-Inch Hard-Drive Cage - Alienware Aurora R12 Service Manual

3.5-inch hard-drive cage

Removing the 3.5-inch hard-drive cage

Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Follow the procedure from step 1 to step 2 in removing the 3.5-inch hard drive, if installed.
About this task
The following images indicate the location of the 3.5-inch and provides a visual representation of the removal procedure.
Steps
1. Remove the two screws (#6-32) that secure the 3.5-inch hard-drive cage to the chassis.
2. Lift the 3.5-inch hard-drive cage off the chassis.

Installing the 3.5-inch hard-drive cage

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-drive cage and provides a visual representation of the installation
procedure.
29