4. Select Verify
5. You can Start/Stop the process by selecting start/stop task
Setting Boot Array
1. Navigate to the array panel (Press ALT + W, then press 2)
2. Select desired array
3. Press ALT + A to open array tab
4. Press Set Boot
5. Window will close, reboot to confirm
Appendix A-4: Controller Tab
Information
Setting...
Controller > Setting Information
Enable Audible Alarm
Enable Staggered Spin up
Provides certain controller information:
•
Product ID
•
PCI Location
•
IOP Model
•
SDRAM Size
•
Firmware Version
•
Battery Installed
•
Battery MB Installed
•
Serial Number
•
CPU Temperatures (Celcius)
•
Board Temperature (Celcius)
•
Controller voltage levels
Configures certain settings:
•
Enable audible alarm
•
Enable Staggered spin up
•
Spin down idle disk (minutes)
•
Enable automatic rebuild
•
Continue Rebuilding on error
•
INT13 support
•
Use single BCV entry
•
Stop on error
Enables/Disables the RocketRAID
controller alarm
(Default: Disabled) Enabling this setting
will force the card to power on each hard
disk sequentially (2 seconds between
disks). Check with your disk
60