Table of Contents
Advertisement
SNP Memory (RMP Table) Coverage
Use this item to configure the SNP Memory (RMP Table) Coverage. When [Enabled] is
selected, the ENTIRE system memory is covered.
Configuration options: [Auto] [Disabled] [Enabled] [Custom]
SMEE
The item controls secure memory encryption enable.
Configuration options: [Auto] [Disabled] [Enabled]
Action on BIST Failure
The item allows you to select the action to take when a CCD BIST failure is detected.
Configuration options: [Auto] [Do nothing] [Down-CCD]
DF Common Options
Press [Enter] to configure DF Common options.
Memory Addressing
Press [Enter] to configure Memory Addressing options.
Memory interleaving
The item allows for disabling memory channel interleaving.
Memory interleaving size
The item contorls the memory interleaving size. The valid values are AUTO, 256 bytes, 1
Kbytes or 2Kbytes. This determines the starting address of the interleave (bit 8, 9, 10 or 11).
DRAM map inversion
Inverting the map will cause the highest memory channels to get assigned the lowest
addresses in the system.
Location of private memory regions
The item controls whether or not the private memory regions (PSP, SMU and CC6) are
st
at the top of DRAM, at the top of 1
DRAM pair or distributed. Note that distributed
requires memory on all dies. Note that it will always be at the top of DRAM if some dies
don't have memory regardless of this option's setting.
Configuration options: [Auto] [Distributed] [Consolidated] [Consolidated to 1st DRAM
pair]
Disable DF to external downstram IP Sync Flood Propagation
The item allows you to disable Error propagation to UMC or any downstream slaves eg.
ECH. Use this to avoid reset in failure scenario.
Disable DF sync flood propagation
The item allows you to disable propagation from PIE to other DF components and
eventually to SDP ports.
Configuration options: [Auto] [Sync flood disabled] [Sync flood enabled]
54
Advertisement
Table of Contents
