Mitsubishi Electric FR-E800 Instruction Manual page 240

 Parameter write enabled during operation (Pr.77 = "2")
• Parameters can always be written.
• The following parameters cannot be written during operation if Pr.77 = "2". To change the parameter setting value, stop
the operation.
Pr.
Stall prevention operation level compensation
23
factor at double speed
40 RUN key rotation direction selection
48 Second stall prevention operation level
60 Energy saving control selection
61 Reference current
Stall prevention operation reduction starting
66
frequency
71 Applied motor
79 Operation mode selection
80 Motor capacity
81 Number of motor poles
82 Motor excitation current
83 Rated motor voltage
84 Rated motor frequency
90 to 94 (Motor constant)
95 Online auto tuning selection
96 Auto tuning setting/status
178 to 197 (Input/output terminal function selection)
261 Power failure stop selection
277 Stall prevention operation current switchover
289 Inverter output terminal filter
291 Pulse train input selection
292 Automatic acceleration/deceleration
293 Acceleration/deceleration separate selection
298 Frequency search gain
313 to 322 (Extension output terminal function selection)
329 Digital input unit selection
415 Inverter operation lock mode setting
418 Extension output terminal filter
420, 421 (Electronic gear)
450 Second applied motor
451 Second motor control method selection
453 Second motor capacity
454 Number of second motor poles
455 Second motor excitation current
Name Pr.
456 Rated second motor voltage
457 Rated second motor frequency
458 to 462 (Second motor constant)
463 Second motor auto tuning setting/status
507 Display/reset ABC relay contact life
508 Display/reset ABC2 relay contact life
525 to 531 (Extension input terminal function selection)
538 Current position retention selection
541 Frequency command sign selection
560 Second frequency search gain
561 PTC thermistor protection level
570 Multiple rating setting
574 Second motor online auto tuning
Inverter output fault detection enable/disable
631
selection
639, 640 (Brake sequence)
660 to 662 (Increased magnetic excitation deceleration)
SF-PR slip amount adjustment operation
673
selection
699 Input terminal filter
702 Maximum motor frequency
706, 707, 711,
712, 717, 721, (PM motor tuning)
724, 725, 1412
(Motor starting resistance tuning
720, 737
compensation coefficient 2)
738 to 746, 1413 (Second PM motor tuning)
800 Control method selection
858 Terminal 4 function assignment
859 Torque current/Rated PM motor current
Second motor torque current/Rated PM motor
860
current
868 Terminal 1 function assignment
979 to 981 (Position accuracy compensation gain 1 to 3)
998 PM parameter initialization
999 Automatic parameter setting
1002 Lq tuning target current adjustment coefficient
1292 Position control terminal input selection
1293 Roll feeding mode selection
8. (E) Environment Setting Parameters
Name
8.10 Parameter write selection
1
2
3
4
5
6
7
8
9
10
239