Advertisement
PEHA Elektro GmbH & Co. KG
Daimlerstraße 4, 58553 Halver · Telefon +49 (0) 2353 9118-001 · Telefax +49 (0) 2353 9118-311 · e-mail: peha@honeywell.com · Internet: www.peha.de
The wall transmitters are part of the PEHA radio system. The
radio transmission takes place at the European harmonised fre-
quency of 868.3 MHz. It is particularly suitable for areas where
no repairs are required, such as renovations, retrofitting of elec-
trical systems or of . fices with mobile walls. By pressing a button,
consumers can be switched wirelessly through receivers.
The transmitters must be assigned to the
receivers.
Therefore,
refer to the receivers operating instructions. Every wall transmit-
ter can control an indefinite number of receivers.
– The wall transmitters function without batteries and are
maintenance-free !
– Read through the operating instructions carefully before
putting the device into service.
These operating instructions are an integral part of both the device and our terms of
warranty. They must be handed over to the user. The technical design of the appli-
ance is subject to change without prior notification. PEHA products are manufactured
and quality-checked with the latest technology according to applicable national and
international regulations. Nevertheless, if a product should exhibit a defect, PEHA
warrants to make remedy as follows (regardless of any claims against the dealer to
which the end-user may be entitled as a result of the sales transaction):
In the event of a justified and properly-established claim, PEHA shall exercise its
prerogative to either repair or replace the defective device. Further claims or liability
for consequential damage are explicitly excluded. A justifiable deficiency is one in
which the device exhibits a structural, manufacturing, or material defect that makes it
unusable or substantially impairs its utility at the time it is turned over to the end-user.
The warranty does not apply to natural wear, unintended usage, incorrect connection,
device tampering or the effects of external influences.
The warranty period is for 24 months from the date of purchase by the end-user from
a dealer and ends not later than 36 months after the device's date of manufacture.
German law shall be applicable for the settlement of warranty claims.
Do not dispose of old devices in the household waste! The device must be
disposed of in compliance with the laws and standards of the country in which
it is operated! The device contains electrical components that must be dispo-
sed of as electronics waste. The enclosure is made from recyclable plastic.
2. Safety
This device is only intended to be used for its stated application. Unauthorised conver-
sions, modifications or changes are not permissible! This device may not be used in
conjunction with other devices whose operation could present a hazard to persons,
animals or property.
Prevailing statutes, standards and regulations.
State-of-the-art technology at the time of installation.
The device's operating instructions.
perating instructions can only cite general stipulations. These are to be viewed in
the context of a specific system.
Internet:................... www.peha.de
868.3 MHZ
10 mW
(ASK Amplitude Shift Keying)
min. 50,000
-25°C to +65°C in dry rooms
0% to 95 %
20m (max. 3 walls)
10m (max. 1 wall/ceiling)
30m (max. 5 walls)
The strength of the radio signal between sender and receiver decreases with
increasing distance. The visually unobstructed range is about 30 m in passageways
and 100 m in open rooms. The range can be increased through the use of an Ea-
syclick repeater.
20-FU-BLS (Rev06-1
90430
)
Component number: 31060000-152
a Honeywell Company
The transmitters are to be completed with the combination frames of the according
switch programme. The combination frames have to be ordered separately!
The following variations of transmitters are available:
O =
FF
= UP
neutral (without label)
Wall transmitter in Aura- / Nova- / Badora-Design
20.450.xx
20.455.xx
1
1
.450.xx
1
1
80.450.xx
80.455.xx
95.450.xx
95.455.xx
250.xx
255.xx
450.xx
455.xx
The Easy t wall transmitter is a universal, extremely at standard switch element
that can be integrated into numerous control programmes by different manufacturers.
The universal element is compatible with the switch programs listed in the table.
Frame integration is similar to universal inserts for antenna sockets.
S1, B1, B3, B7Glas
Standard55, E2, Event, Esprit
A500, Aplus
M-Smart, M-Arc, M-Plan
=
N
= D WN
Retaining plate
.455.xx
Retaining plate
Retaining plate
Retaining plate
Retaining plate
1
2
Do not use in the open (only within closed rooms).
Before the installation on rough surfaces, a smooth surface has to be created.
Unevenness may lead to transmitter's malfunctions.
When installing, mind the required position of installation shown on the back of
= top , I = bottom)
the transmitter (
.
Do NEVER install the transmitter within a metal body or in the immediate vicinity
of big metal objects. An installation near or on the ground is not recommendable.
Retaining plates
shall be used as a template to mark the drill holes.
Drill dowel holes of 5 mm.
Fix the retaining plate with included screws. The latches of the retainin plate
have to be positioned for their installation as shown under
Engage wall transmitter
and frame
on the retaining plate.
Engage wall transmitter
and frame
on the retaining plate
Use adhesive strips for the installation on flat, smooth surfaces (such as
painted walls, tiles, furniture, wood, etc.) Glue the adhesive strip to both
the upper and lower recess on the indentation of the retaining plate.
Use adhesive film for the installation on glass. Glue the adhesive film to the
inverse side of the retaining plate.
Glue the assembled wall transmitter to the desired place.
Installation of the receiver (only by an electrician).
Assign wall transmitter to receiver.
Check the immediate surroundings of the systems for changes that might cause
malfunctions (for example, previously moved metal cabinets, furniture or walls).
If transmitter/receiver work at a closer distance, there either might be interference
or the system was used outside the transmission range.
Placement of the transmitter at a more convenient location.
Use of the transmitter/receiver in the vicinity of metal objects or materials with
metal components. Maintain a distance of at least 10 cm.
Moist materials.
Devices which emit high-frequency signals (e.g. audio and video systems, compu-
ters, electronic ballasts in lightfixtures). Maintain a distance of at least 0.5 m.
Telephone:................ +49 (0)2353 9118-001
Fax:.......................... +49 (0)235
3 9118-311
Internet:.................... www.peha.de
E-mail:...................... peha@honeywell.com
7.
PEHA products may be sold and operated in EU countries as well as in CH, IS
and N. PEHA herewith declares that the Easyclick wall transmitter is in compliance
with the fundamental requirements and other relevant provisions of R&TTE Directive
1999/5/EC. The conformity declaration is available on the Internet at the following
address: www.peha.de
.
.
GB - 1
Advertisement
