Maintenance - Ryobi PCL540 Operator's Manual

DANGER:
Do not cut electrical outlet openings with live electrical
wires. Do not cut walls that could have live electrical
wiring behind them. Shut off breakers or remove fuses to
disconnect the circuit. Always hold the tool by its motor
housing.
WARNING:
When servicing use only identical replacement parts. Use
of any other parts can create a hazard or cause product
damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
BITS
Get faster and more accurate cutting results by keeping bits
clean. Remove all accumulated build-up from bits after each
use. Replace bits when they become dull.
NOTE: ILLUSTRATIONS START ON PAGE 9
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ADJUSTING DEPTH OF CUT
See Figure 8, page 10.
 Remove battery pack.
 Release the depth lock lever.
 Move wrench/depth guide to desired position.
 Engage the depth lock lever to secure the wrench/depth
guide in place.

MAINTENANCE

The bit flutes are sharp and should be handled with
caution.
COLLET
Over time it may become necessary to clean the collet and
collet nut. To do so, simply remove collet nut and collet from
the shaft and clean the dust and chips that have collected.
Then return collet nut to its original position. Tighten collet
nut on collet without a bit installed.
8 - English
CAUTION: