Hot Water Delivery Temperature - Rinnai HD32e Operation & Installation Manual

HOT WATER DELIVERY TEMPERATURE

This appliance may deliver water at high temperature. Refer to the Plumbing Code of Australia
(PCA), local requirements and installation instructions to determine if additional delivery
WARNING
temperature control is required.
Local regulations and or the requirements of AS/NZS 3500 MUST be addressed regarding the temperature
areas may be limited to 50°C or less. To ensure these regulations and or requirements are met the system MUST
This appliance MUST
WARNING
control is inadequate.
is
If the appliance is to deliver water primarily for the purposes of personal hygiene in an early
childhood centre, primary or secondary school, nursing home or a similar facility for the care of
IMPORTANT
(TLD), such as a Tempering Valve may be required even if the appliance is set to 50º C or less. For
these types of applications contact Rinnai.
Diagram 1 : 50°C Appliance
50º C
Minimum length of pipe from hot outlet
to nearest hot water tap 2 metres.
NOTE
Rinnai
Water controller
ENSUITE
(optional)
Water controller
LAUNDRY
(optional)
Water controller
BATHROOM
(optional)
Water controller
KITCHEN
(optional)
GENERAL INSTALLATION INFORMATION
Diagram 2 : NOT a 50°C Appliance
Water controller
(optional)
KITCHEN
TLD = Temperature Limiting Device.
NOTE
19
Water controller Water controller Water controller
(optional) (optional) (optional)
LAUNDRY ENSUITE BATHROOM
TLD
HW_CF OIM