Panasonic CZ-RTC6BL Installation Instructions Manual page 9

2
Mount to the wall.
There are 2 types of wall-mounting methods: Exposed type and Embedded type.
Attention
Mounting the bottom case
 Tighten the screws securely until the screw heads touch the bottom
case.
(Otherwise, loose screw heads may hit the PCB and cause
malfunction when mounting the top case.)
 Do not over-tighten the screws.
(The bottom case may be deformed, resulting in the unit becoming
detached from the surface it is fixed to.)
Connection to the remote controller terminal board
 Depress the push button using a round bar or fi nger, insert the
remote control wiring securely from the wiring insertion slot and
release the push button.
 Pull the remote control wiring lightly, and confi rm it is secured.
 There is the danger of shorting if copper wire is exposed. Make sure
the wire is properly inserted.
A protective fi lm is attached on the Control panel.
3
Mount the top case.
● Align the claws of the top
case and then align the
claws of the bottom case.
Avoid the
wire being
caught.
Claw (2 locations)
2
Connect the remote control wiring.
• Be sure not to allow unnecessary wires to remain
in the remote controller case when wiring. Be
careful not to allow wires to be in contact with
parts on the PCB. For connection method, refer
to "Connection to the remote controller terminal
board" in "Attention".
Exposed type
1
Mount the bottom case to the wall.
● Pass the wire through the wiring
hole in the bottom case and lay the
wire out along the groove.
Hole for screw
Claw (2 locations)
Screw
(Supplied)
Insertion slot
Remove the coating. Approx. 9 mm
Remove the sheath. Approx. 130 mm
● Make sure the wiring connection is in the
Cut here with
correct direction.
a nipper and
● There will be a slight diff erence in length due
remove the burr
to the wiring diameter, so make adjustments
with a file.
on site when performing the installation.
Push the sheath Push the sheath
in to the back as in to the back as
shown on the shown on the
illustration. illustration.
Insert the wire properly Insert the wire properly
into the channel on the into the channel on the
bottom case, and make bottom case, and make
sure the wire is not sure the wire is not
pinched when the case pinched when the case
is attached to the wall. is attached to the wall.
• Insert the clamper from the
position indicated by the arrow,
as shown in the diagram at right.
• Put the locking part of the
clamper in the channel as
indicated by the arrow.
• If you lock at the top, it may not
be possible to close the bottom
case.
*It is also possible to mount in the order
Push button
Remote controller terminal board
Remote controller
terminal board
Clamper
(supplied)
2 3
→ 1 → .
9