Download Print this page

Setup And Operation; Service - Honeywell F59A Manual

Console 3-speed electronic air cleaner
Hide thumbs Also See for F59A:

Advertisement

WHEN USING THIS PRODUCT...
Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous condition.
UNPACK ELECTRONIC AIR CLEANER
Check that all components are included. The electronic
air cleaner is shipped assembled. See Fig. 1.
SET UP ELECTRONIC AIR CLEANER
Position the F59A so:
• the airflow in and out of the air cleaner is not
blocked or partially obstructed.
• the discharge air does not cause uncomfortable
drafts for any occupant.
• the power cord does not interfere with normal occu-
pant traffic.
Remove and discard the cardboard liner next to the
electronic air cleaner cell.
Remove the cell and carbon postfilter from the cabinet;
remove and discard the plastic cover from the carbon
postfilter.
Replace the cell and the carbon postfilter. Make sure
cell is placed correctly, with directional arrows pointing
toward center of air cleaner cabinet. The cell directional
arrow is located on the side of the cell. The prefilter and
carbon postfilter should be placed with the wire mesh
toward the center. See Fig. 2.
Plug power cord into standard grounded outlet.
OPERATION OF ELECTRONIC AIR CLEANER
Select desired airflow rate with three-speed power
switch—LO, MED or HI. For maximum air cleaning
CAUTION
SHARP EDGES.
CAN CAUSE PERSONAL INJURY.
Handle the cell carefully to avoid cuts from the
sharp metal edges.
CLEANING THE CELL AND PREFILTER
Clean the cell and prefilter regularly—every one to six
months. Variables such as number of occupants, pets,
activities and smoking will determine how often cleaning is
required. Use the wash reminder schedule included with
the air cleaner to help establish and maintain a regular
cleaning schedule.
The cell can be washed in many automatic dishwashers,
by soaking in a tub or a do-it-yourself coin operated car
wash. The prefilter can be vacuumed, brushed or soaked in
a tub. Do not wash the filter in the dishwasher or carwash.
SETUP AND OPERATION • SERVICE

Setup and Operation

Fig. 2—Make sure cell and filters are placed
correctly.
DIRECTIONAL ARROW
(POINTING TOWARD
CENTER OF
CABINET
M9683
benefit, leave switch on HI at all times. For quiet
operation, use LO setting. Neon light and fan should be
on whenever air is running.
Move power switch to OFF to turn off electronic air
cleaner; neon light and fan will go off.
NOTE: An arcing (snapping) sound may be heard occa-
sionally as air cleaner operates. This sound means air
cleaner is working as it should, collecting large airborne
dust particles.
Automatic Dishwasher
CAUTION
BURN HAZARD.
CAN CAUSE PERSONAL INJURY.
Allow the cell to cool in the dishwasher at the end
of the wash cycle or wear protective gloves to
avoid burns. Hot water can accumulate in the
tubes supporting the collector plates. Tip the cell
so these tubes will drain.
IMPORTANT:
• Check you dishwasher owner manual. Some manu-
facturers do not recommend washing electronic cells
in their dishwasher.
• If the dishwasher has upper and lower arms, care-
fully position the cell to allow good water circula-
tion.
3
CARBON
INSERT FILTER WITH
POSTFILTER
WIRE MESH TOWARD
CENTER OF UNIT
CELL
PREFILTER

Service

68-0086—5
F59A

Advertisement

loading